[Jan-2022] Pass HP HPE2-W09 Tests Engine pdf - All Free Dumps [Q36-Q60]

Share

[Jan-2022] Pass HP HPE2-W09  Tests Engine pdf - All Free Dumps

Aruba Data Center Network Specialist Exam Practice Tests 2022 | Pass HPE2-W09 with confidence!


HP HPE2-W09 Exam Syllabus Topics:

TopicDetails
Topic 1
  • Understand how to use the ArubaOS-CX Network Analytics Engine (NAE) to enhance monitoring and troubleshooting
  • Describe common data center networking requirements
Topic 2
  • Understand, describe and configure Ethernet Ring Protection Switching (ERPS)
  • Understand, describe and configure VXLAN functionality
Topic 3
  • Understand how to use NetEdit to simplify ArubaOS-CX device configuration
  • Understand the components of the ArubaOS-CX Switching architecture
Topic 4
  • Describe the benefits of VSX for a data center networking environment and implement VSX
  • Understand, describe and configure Datacenter Bridging (DCB)
Topic 5
  • Understand, describe and configure EVPN to transport VXLAN thru the datacenter
  • Understand, describe and configure VRF
Topic 6
  • Describe data center network design principles, including data center deployment models and the impact of various data center technologies on design

 

NEW QUESTION 36
You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You cannot leak multicast routes.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 37
Refer to the exhibits.


Is this how the switch handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.2. but not 192.168.1.3.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 38
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: omit the device-specific settings from the configuration plan and include them in command scripts instead.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 39
Is this something that NetEdit 2.0 does after it discovers a switch?
Solution: It enables the switch REST API Interface, if disabled.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 40
Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISL between Switch-1 and Switch-2. enable Equal Cost Multi Path (ECMP) on both Switch-1 and Switch-2.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 41
Is this a way that Virtual Switching Extension (VSX) differs from Virtual Switching Framework (VSF)?
Solution: VSX permits admins to select which features to synchronize between members while VSF requires manual configuration of Identical features on each member of the VSF fabric.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 42
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: IMET routes advertise the MAC addresses that the VTEP has learned locally in a VXLAN.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 43
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Inside a configuration plan, light-click any device-specific parameters and modify the parameter per-device.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 44
Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?
Solution: Automated configuration of Layer 3 MP-BGP protocol on leaf switches

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 45
You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The guard interval is set in units of seconds and is used to prevent frequent topology changes due to a link going up and down.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 46
Does this correctly describe how Network Analytics Engine (NAE) agents work?
Solution: Agents write data to the switch's current state database.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 47
Refer to the exhibit.

You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch's loopback interface.
Is this part of the process for setting up VXLAN to meet the requirements?
Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 48
Is this how you should position switches in the ArubaOS-CX portfolio tor data center networks?
Solution: Deploy Aruba 83xx switches as data center leaf switches.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 49
Is this a guideline for establishing a Virtual Switching Extension (V5X) Inter-Switch Link (ISL) between two ArubaOS-CX switches?
Solution: Use the same speed on every link In the ISL.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 50
Refer to the exhibit.
Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add VRF B as the secondary VRF on VLAN interface 30.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 51
You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Protection, which means that the ring is up and fully connected with the RPL port blocked.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 52
Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) enables multiple isolated Layer 3 domains, each with its own routing table, to share a physical network.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 53
You want to use NetEdit to configure an AtubaOS-CX switch.
Is this a minimum requirement for setting up communications between the switch and NetEdit?
Solution: Make sure that the SSH server is enabled.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 54
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 55
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 56
Does this correctly describe NetEdit's notification capabilities?
Solution: NetEdlt can send an error link to admins through ServlceNow.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 57
You want to use NetEdit to configure an AtubaOS-CX switch.
Is this a minimum requirement for setting up communications between the switch and NetEdit?
Solution: Enable the REST interface in read-only mode.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 58
Refer to the exhibits.


Is this how the switch-1 handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN 10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.3, out not 192.168.1.2.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 59
Refer to the exhibit.

You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Place ad three VRF$ in the same OSPF process on Switch-1.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 60
......

Get instant access to HPE2-W09 practice exam questions: https://drive.google.com/open?id=1QwMf-CgaJgZWWE94CwvlAZ_kB0Dd1tHr

Online Exam Practice Tests with detailed explanations!: https://www.testpassed.com/HPE2-W09-still-valid-exam.html